Top synthetic blood penetration test equipment wholesale? GESTER instruments is a national high-tech textile testing equipment manufacturers engaged in R&D and production of high precision physical properties textile testing instruments with 22 years experience, expertly specialized in providing integrated laboratory testing solutions for children’s products, textile, footwear and furniture. It has passed ISO 9001 certificate, “AAA Enterprise in Quality, Service and Credit” and was audited as SGS audited supplier. Find more info at bacterial filtration efficiency test.
Pneumatic Bursting Strength Testing Machine For determining the bursting strength of woven or knitted fabrics, non-woven, paper, leather and board by application of a pneumatic load under a rubber diaphragm of a specific area. Provide with a digital readout of pressure with peak value hold facility, renewable rubber diaphragms, and manual clamping device with acrylic bell, forward reverse and neutral drive system. Provide accurate elongation information of fabrics, up to 0.1mm.
Correct use of computerized universal testing machine: When opening the clamp to take the sample, pay attention to the clamping distance of the sample, not too much or too little. When the tensile testing machine and the microcomputer are connected, the operation must be carried out according to the program requirements. It is strictly forbidden to operate the program due to illegal operation; The parameters to be printed check whether the printer has paper and replenish it in time before printing. After the operation is completed, shut down the tensile testing machine for rubber according to the program requirements. It is strictly forbidden to cut off the power directly.
The values stated in SI units are to be regarded as the standard, with the exception of mils when determining coating thickness.Test Procedure: The haze or original weight of test specimen is measured. The test specimen is then placed on the taber wear and abrasion tester. A 250, 500, or 1000-gram load is placed on top of the abrader wheel and allowed to spin for a specified number of revolutions. Different abrading wheels are specified. A haze measurement or final weight is taken. The load and wheel can be adjusted for softer and harder materials.
Equip with procedure time counter, digital temperature controller, auto temperature & time control, it has alarm hint while experiment ending.Can customize cup compound mode according to customers requirements. Samples Preparation: Place the samples and multi-fiber adjacent fabric under the constant temperature and humidity (temperature: 21±1℃, humidity: 65%±3%) for 4 hours. Cut 40mm*100mm specimen and multi-fiber adjacent fabric, and suture the specimen and multi-fiber adjacent fabric face to face along one short side. Discover more info at gesterinstruments.com.